Drayton digistat 4 user manual

pm Temperature ICC C pm 70 * C if selector pin removed, see installation instructions TO VIEW OR CHANGE THE FACTORY SETTINGS (steps 5- I O) During norrnal operation, the Digistat 2 will display actual room temperature continuously. SETTING THE TIME OF DAY (steps I _4). 1. Do not install the Digistat +RF transmitter until after you have completed the commissioning process. 2. Pull down the battery drawer in the Digistat unit and the screen will go blank. 3. Turn off the power supply to the SCR receiver unit and leave for 5 seconds. 4. Turn the power back on to the SCR unit and check red light is on. 5.  · SPORTCRAFT TX RC Installation Manual English DRAYTON Digistat RF2 User’s Guide English REPAIR SERVICE 4 Drayton / Iflo / British Gas Digistat SCR Wireless Thermostat. £, + £ Programmable, manual and remote wireless stat options.

Drayton Digistat +3RF Invensys Controls Europe Customer Service Tel: 08Customer Service Fax: 08Technical Helpline Tel: 08Website: www.doorway.ru Email: www.doorway.ru@www.doorway.ru User Guide IssA Programmable Room Thermostat Wireless Day /7 Day Model: RF/ Power Supply. he Digistat +2RF thermostat is a programmable thermostat. Hour (the same program for every day of the week) and. allows you to set 6 time and temperature events per day. Digistat +2RF Pre-set Program. Y. our Digistat +2RF comes with the following default settings. pre-programmed for your convenience. Drayton Digistat 2 User Instructions Manual. User Manual: Drayton Drayton-DigistatUser-Instructions Open the PDF directly: View PDF. Page Count: 2.

View the manual for the Drayton Digistat +RF2 here, for free. This manual comes under the category Thermostat and has been rated by 1 people with an average of a This manual is available in the following languages: English. pm Temperature ICC C pm 70 * C if selector pin removed, see installation instructions TO VIEW OR CHANGE THE FACTORY SETTINGS (steps 5- I O) During norrnal operation, the Digistat 2 will display actual room temperature continuously. SETTING THE TIME OF DAY (steps I _4). 4. The red and green LED’s should both now be on. 5. Take the Digistat RF and hold it within sight of the SCR (no closer than one metre). 6. Remove the battery cover and fit the batteries. 7. The Digistat RF should now display the actual room temperature. If the unit has been stored in a cold place, it may take time to warm up. 8.